The Pentair QuickTouch II Remote allows remote control of a Pentair SunTouch, EasyTouch, or IntelliTouch Pool Automation system. We have installed lots of these convenient remotes with SunTouch Solar Pool Heating controllers. Pairing the Pentair QuickTouch II Remote With The Receiver is easy!
Once in a while, the remote may lose connection with the receiver, which is located outside near your pool equipment. Opening the receiver requires a #2 Philips screwdriver. The screws are located on the bottom of the antenna housing. When sliding the cover off the receiver, be VERY CAREFUL that you do not break off the antenna, which is integrated with the circuit board.
The instructions (attached below) tell you to press the white button on the circuit board. Be aware that some QuickTouch units have shipped with blue or black buttons despite what the instructions read. The steps are as follows:
- Open receiver case.
- Press the White Receiver button (shown below).
- An LED on the QuickTouch II receiver will flash three (3) times (once the Receiver button is pressed, you have 60 seconds to connect the QuickTouch II remote to the receiver).
- Hold down button four (4) and button eight (8) simultaneously.
- The QuickTouch II remote can now communicate with the receiver. Check all of the remote buttons to make sure they operate correctly.
If your remote is still not doing what is expected, but it is paired with the remote, you will need to check the programming on the SunTouch using menu 12/14. Check your SunTouch manual for more information.
Here is the QuickTouch Owners Manual available for download.